Behringer EUROPOWER EP2000 Professional 2,000-Watt Stereo Power Amplifier with ATR (Accelerated Transient Response) Technology

Product Information

Watts represent the amount of energy produced by the amps and volts working together. Multiplying amps (water volume) by volts (water pressure) gives you the wattage (the resulting power or energy). A water wheel would turn faster and longer, generating more energy if If you’re figuring out current loads for an inverter, though, you may need to add 10% or more to these calculated amperage values, depending on how efficient your inverter is. Calculating Amperage in an AC Circuit Asia, the current changes direction 50 times per second, which is 50Hz. Power supplied to homes and businesses uses AC supply. Watts to amps conversion examples The XGA-2000 provides you with 2000w of peak power with 250w of RMS power which is more which is ideal for powering PA systems and DJ rigs while a DC output protector and short circuit protection prevent your speakers from being overloaded. This amplifier also ensures a seamless, reliable performance thanks to the front-to-rear airflow and fan cooling system that gives you thermal stability so your system will not overheat.

Impedance – Impedance is the electrical resistance of your components. This can be easily seen in the manual or specs sheet of your speakers and amplifiers. The impedance of both speakers and amplifiers must be compatible to deliver high quality sound. The general rule is that it is OK to connect speakers with a higher impedance than amplifiers, but never the other way around. For alternating currents, the 2000 watts amps transformation is different for a single phase and a three phase system; the power factor is needed in both cases. Stage vibrations, mic thumps and wind noise can cause ultra-low frequency sounds, or infrasonics – and while technically inaudible, they can be a real drain on power resources. As a solution, the EP4000 features a defeatable Low Cut Filter that eliminates frequencies below either 50 or 30 Hz (depending on your PA system’s capabilities) – for better sonic performance, as well as the ultimate in loudspeaker protection. The rear panel also contains the Stereo or Bridge (mono) mode switches. it uses increased water volume and higher water pressure; the same applies to the wattage if amps and volts are increased. What are volts?For single-phase systems, as shown in the formula for it, we need to first multiply the power factor by the voltage. Let’s assume the power factor is 0.7, which is typical for a single-phase motor system, and the motor is on a 240V circuit. Wattage – Wattage in speakers refers to how much power it can receive while the wattage in amplifiers refers to how much power it can give out. For optimum pairing, read the continuous power and the output wattage of your amplifier, then match it with the recommended amplification levels of your speaker.

These answers apply to a similarly related question like, “How many amps to run 2000 watts?” You may take these values as they are if you’re calculating amperage in a generator. Professional speaker connectors and "touch-proof" binding posts support most speaker wiring systems Class AB – this class is most often used to support car audio systems. It combines both strengths of the Class A & B amplifiers.

An error has occurred

Sensitivity – This refers to how loud a speaker is in decibels when measured 1 meter away, and with the speaker being powered by one watt of power. Knowing your speakers’ sensitivity will help you gauge how much power is still needed to support an amplifier to achieve your desired sound level. The rear panel of every EUROPOWER EP2000 sports an array of options to help you get the most out of your amp. The built-in Clip Limiter automatically senses when the amplifier is being driven into “clipping” and momentarily reduces the input level to avoid distortion. This all happens in mere micro-seconds, making it the ideal way to ensure perfect sound all the time. Third, that new piece of gadget must just not be a new toy. It must be an investment piece that will allow you to max out or at least sufficiently use its claimed capacity without easily conking out on you. It must be able to last you some good years.