Apollo Ultrasonic Füllstands-Sensor Standard Standard Betriebsspannung (Bereich): 150-250 V/AC 1S

Product Information

Tank Level Monitor 20934,21616 19225,18801,20934,13081,13079,13077,13075,20251,19346,13079,20785 17899 67.

In the event that the tank is filled to the top, this will not harm the transmitter as it is a sealed unit. The Apollo Oil Tank Gauge is an easy to retrofit, ultrasonic level indicator generally used as a domestic oil tank gauge. Pity it does not have a backlight which would make the gauge easier to read but its a minor quibble. Remember to switch the power off and then back on before rematching to allow for receiver plug to go into teach mode. What if the oil in the tank is full to the very top, will this harm the Apollo transmitter and will I receive a correct reading?

Yes, you can use either unit on a bunded tank to measure the oil level however this will not alert you should you have an oil leak to the inner tank. Thanks to their hydrophobic nature, these oil spill absorbent pads will not soak up water and will float on top even when completely saturated, which makes them suitable for applications where oil and water must be separated.

In this case, remove the transmitter from the tank, check for the correct dipswitch settings on the back of the receiver, which corresponds to your tank height and rematch by following the installation instructions. The Apollo Visual Ultrasonic comes with two parts, firstly a tank mounted ultrasonic transmitter with level readout compatible with most modern plastic fuel storage tanks that have a 32mm port usually fitted to the tank. This information is displayed on the transmitter’s integral LCD display and also relayed wirelessly to the receiver unit. Certainly, the Apollo can be used on multiple piped tanks to measure the level provided the tanks are the same shape and capacity with open pipework linking the tanks. The receiver unit displays the level of fuel inside the tank, via an easy to read LCD display, which usefully includes a low level warning alert.

The lithium (CR2430 supplied) battery operated transmitter fits plastic or steel tanks up to 3 metres high and transmits up to 200 m to the receiver, which will auto-reset after a power failure. Perfect in the agricultural sector for refuelling heavy vehicles and machinery, the K150 ATEX high capacity mechanical meter is suitable for all those sectors that need to operate on vehicles with large tanks. I have lost the instructions – how do I rematch the unit and how do I know what Pin settings to set on the rear of the receiver plug. The Apollo transmitter uses high-quality FM signal because it is less prone to interference when compared to AM signal.

AdBlue® is a registered trade mark of the German Association of the Automotive Industry and Atlantis Tanks Group are not associated with AdBlue® or the German Association of the Automotive Industry. Apollo is the revolutionary way to take control of your fuel and allows you to monitor the level of fuel inside your oil tank, from the warmth and comfort of your home or office. Ideal for monitoring heating oil and diesel but suitable too for a wide range of liquids including admixtures, agricultural fuel oil, anti-freeze, biodiesel, bio heating oil, fuel oil, detergents, lubricants, waste oil and water.The bund-warning element is the float switch, which is attached/hardwired to the base of the transmitter. The Tank Dryer, or 'tank sock' as it is often referred to, contains highly absorbent silica gel, which when lowered into the tank absorbs up to 350ml of water. A tank-mounted ultrasonic transmitter unit, compatible with the standard 32mm port fitted to modern plastic fuel storage tanks.