About this deal
PVC Connector 75mm Glue - 11/2" Male Thread 16 Bar Rated VDL is a producer of injection molded fittings for PVC and PE pressure pipe systems.
PVC Reducing Tee 16 Bar Rated 75mm x 75mm x 40mm (Outside Pipe Diameter ) VDL PVC injection moulded fittings offer a comprehensive range of high quality high pressure PVC fittings. PVC fittings are suitable to use in many applications including spray lines, drip lines, pump and valve manifold.
VDL 45º Swept Elbow 10 Bar Rated 75mm PVC swept elbow is used for high flow situation PVC pipe fittings are suitable for use with high pressure flowing liquids VDL is a producer of injection moulded fittings for PVC and PE pressure pipe.
All fittings and pipework have smooth bores which aid in good flow characteristics and resistance to abrasion. The pipe is suitable for use with liquids up to 45 centigrade however the higher the temerature the lower the maximum permissable running pressure. Brymec HDPE is manufactured from high density polyethylene, which has numerous advantages over other materials. A 63mm pipe will fit inside the fitting or a 75mm fitting will fit inside a 63mm connector VDL is a.PVC Equal Tee 16 Bar Rated 75mm x 75mm x 75mm (Outside Pipe Diameter ) VDL PVC injection moulded fittings offer a comprehensive range of high quality high pressure PVC fittings. Our well trained staff have many years of experience in Horticulture, Agriculture, Parks, golf and domestic irrigation.
PVC Elbow 90 Degrees 16 bar 75mm Glue Glue VDL is a producer of injection moulded fittings for PVC and PE pressure pipe systems. High chemical resistance and good flow characteristics make PVC pressure piping system the safe and secure choice for potable water and food products supply. mm fittings and pipe 20 mm fittings and pipe 25 mm fittings and pipe 32 mm fittings and pipe 36 mm = 1. The dimension of the pipe (75 mm x 3,6 mm) is to be understood as follows: The first mm refers to the outside diameter, the second dimension refers to the thickness of the pipe.VDL 90º Swept Elbow 10 Bar Rated 75 mm PVC swept elbow is used for high flow situation PVC pipe fittings are suitable for use with high pressure flowing liquids VDL is a producer of injection moulded fittings for PVC and PE pressure pipe.
You can earn a minimum of 1 point for every pound and you can also take advantage of special promotions to increase your point totals.Weld On Wet R Dry UPVC Cement 250 grams 240 ml Medium bodied, extremely fast setting, low VOC PVC cement for all classes and schedules with interference fit through 6″ (160 mm) diameter, Schedule 80 through 4″ (110 mm) diameter. PVC Reducing Tee 16 Bar Rated 75mm x 75mm x 50mm (Outside Pipe Diameter ) VDL PVC injection moulded fittings offer a comprehensive range of high quality high pressure PVC fittings. New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging . NOTE: Wall thickness and Internal Diameter may vary from the chart above, but pressure rating and Outside Diameter always remain the same. In addition to the manufacturers standard warranty (usually 1 year) we also offer the opportunity for you to extend this warranty by a further 1 year for a one off fee.