Ubiquiti UniFi 6 Pro Acces Point Wifi 6 AP 5.3Gbps 300+ clients (U6-PRO), dual band

Product Information

So, I adjusted the settings to broadcast the signal at 80MHz and reconnected the WiFi 6 client device (AX200). As expected, the close-to-Gigabit speeds are gone, but the throughput is not bad. At 5 feet, upstream, I saw an average of 735Mbps, while downstream, it was 349Mbps. Ubiquiti U6-Pro – Wireless Test – 5GHz – WiFi 5 and WiFi 6 client devices – Upstream Ubiquiti U6-Pro – Signal Strength – 5GHz – WiFi 5 and WiFi 6 client devices – Upstream The U6-Pro switches from MediaTek to a Qualcomm chipset. Generally speaking, Qualcomm’s solutions are better than an equivalent MediaTek chipset. I’m glossing over a lot of details there, but the underlying differences are enough that Ubiquiti classifies the U6-Pro as a 6th generation device, while the U6-Lite and U6-LR are both 5th generation. Please Note: The UAP-PRO is no longer available. For an alternative, we recommend the UAP-AC-PRO . Ubiquiti UniFi Pro Access Point (UAP-Pro) I’ve seen this approach with lots of EnGenius access points, including the ECW230 and the latest WiFi 6E ECW336, and it works wonders for the heat management of compact access points. Ubiquiti still insists that their APs are suitable for outdoors, so there are no ventilation holes and you do get a silicone cover for the ports area, which means that the device will get hotter to the touch when it’s operational (due to the heat transfer), but there should be no risk of overheating. Ubiquiti U6-Pro Heat Management. The U6-Lite is the cheapest and least-powerful Wi-Fi 6 AP UniFi offers. It has the least range and performance, but it also has the lowest price and smallest size. It’s the same size (and uses the same mount) as the older AC-Lite and nanoHD. It is not dust or water resistant, and should only be used indoors.

Opening up the U6-LR was a pain in the behind, but the Ubiquiti U6-Pro is even worse. The top plastic part is glued to the bottom section and even if I was using a heat gun, I still had to scratch and deform the case to finally be able to pop the top part off (this time, my fingers remained relatively intact). Ubiquiti U6-Pro Antenna Positioning. I have been using the UniFi U6 Lite in my home for many months now and have been impressed by how much it improved Wi-Fi in my home. Range is very good and so are transfer speeds. But how does it compare to the other U6 models? In any case, on the bottom of the Ubiquiti U6-Pro, there is a dedicated area carved into the plastic where you can find the Reset button and a single Gigabit Ethernet port which supports PoE (802.3af). Left: Ubiquiti UAP-AC-PRO. Right: Ubiquiti U6-Pro.P 8 = Use 8 parallel streams. Without parallel streams, the default TCP window and buffer size of iPerf doesn’t always saturate a fast wireless channel. To maintain consistency I ran all my tests with the default window and buffer sizes, with 8 parallel streams. The Ubiquiti U6-Pro UniFi WiFi 6 Access Point is an indoor WiFi 6 AP with 5.3Gbps over the air speed and a 300+ client capacity. The U6-Pro is a dual-band WiFi 6 (802.11ax) access point that represents the next generation of high-performance wireless technology for home and enterprise users. Delivering blazing fast over the air speeds of up to 5.3 Gbps over its 5GHz and 2.4GHz channels, the U6-Pro will maximise the WiFi experience of any residential or office deployment. Plus, with its ability to support over 300 concurrent clients, the U6-Pro ensures reliable wireless coverage across even the most device-dense environments. The U6-Pro also marries power with ease of use through streamlined setup, configuration, and mobile-friendly management via the UniFi Network app. Easy to Deploy and Manage! When everything is working properly, then the LED will be solid blue and, before it’s adopted to the UniFi controller, it will be solid white. What’s very problematic is that Ubiquiti has advertised that the users would be able to set the color that they wanted (RGB), but they have removed that feature. I have no idea why because as I said, the single LED pales in comparison to the traditional array of LEDs anyway. Why not have some fun? The AC-Mesh and AC-Mesh-Pro are still relevant, but are also due for an update. Ubiquiti hasn’t replaced these models with direct replacements, but they have made newer outdoor APs that can be considered instead. Wi-Fi 6: U6-Mesh The AC-Mesh-Pro is an AC1750 Wi-Fi 5 AP, offering more performance than the non-pro model. It doesn’t have removable antennas, but instead comes with high-gain (8 dBi) antennas built-in. The AC-Mesh-Pro is big enough that it could act as a lunch tray. It is harder to hide, but the additional antenna gain provide impressive range and performance. The AC-Mesh-Pro can operated on standard 802.3af (15W) PoE, or with Ubiquiti’s 48V passive PoE.

Before getting to the actual results, I need to mention that a PoE adapter or switch is mandatory, and I used the Zyxel XS1930 which was way overkill for a Gigabit connection, but I had it already installed from when I tested the EnGenius ECW336 (not that Ubiquiti actually sends me anything, let alone an Ethernet switch). So, as I did with the U6-LR, I used three client devices, one with a WiFi 6 adapter and two with WiFi 5 cards. Ubiquiti U6-Pro vs U6-Lr vs Zyxel WAX650S vs WAX630S – Long-term speed test – 80MHz – Upstream – 5 feet.

Benefits of our UniFi Cloud Hosting Service

Statistics: Ubiquiti organizes and visualizes your network(s) traffic in clear and easy-to-read graphs. And, since the Ubiquiti U6-Pro supports 160MHz channel width, I tried to keep the interference to the minimum to see the maximum performance that the AP can reach. At closer range (5 feet), the QCN9024 is absolutely phenomenal, delivering an average of 934Mbps upstream and 625Mbps downstream. Ubiquiti U6-Pro vs Other WiFi 6 Access Points – 5GHz (80MHz) – 5 Feet – Upstream.

There is a bump in the antenna gain of 0.5dBi for the 5GHz, while the transmit power is 22dBm as opposed to the 26dBm of the U6-LR, the platform is also different but is that enough to make a noticeable difference between the two models? There should be a difference, but I am not sure it’s going to be that steep, hence the small difference in terms of cost between the two models.The UniFi Access Point (UAP) U6 family consists of 5 models: the U6 Lite, the U6 Pro, U6 Long-Range (LR for short), U6 Enterprise, and the U6 Mesh. The U6 LR unsurprisingly has the best performance (speed and range) across both 2.4 GHz and 5 GHz bands, thanks to the highest signal strength and 4×4 MIMO on all bands. The Ubiquiti UniFi Prooffers simultaneous dual-band operation with 2x2 and 3x3 MIMO technology. It has a range of up to 400 ft and 2 Gigabit Ethernet ports.The UAP Prois faster than the standard UAP model, offering speeds of up to 300 Mbps in the 5 GHz radio band and up to 450 Mbps in the 2.4 GHz radio band.

For my next test, I tested from 3 different places in my house. I wanted to show the impact of distance from your AP on a typical 20 MHz 2.4 GHz or 80 MHz 5 GHz channel. The above tests were very close range, and were meant to show an absolute best-case scenario. These distance tests are more realistic, and the 15 feet + 1 wall results are more likely what you will see in typical use. As the name implies, the U6-LR offers more range than the U6-Lite. The U6-LR has twice the spatial streams (2x2:2 vs. 4x4:4) in both bands, resulting in better beamforming and higher potential throughput. It is physically much larger, the same size as the AC-HD. The U6-LR is a step up in nearly every way, but it still has an older 802.11n-era 2.4 GHz radio and MediaTek chipset like the U6-Lite. The U6 Lite supports only WiFi4 (802.11ac) on the 2.4 GHz band, but the others support WiFi6 (802.11ax) on the 2.4 GHz band. The curious thing is that the industry wants to push us now towards WiFi 6E. Slow down, guys, you’re not going to pull this off in the WiFi networking market, although I applaud your effort. I know people that are still using 802.11n (WiFi 4) routers, so the adoption at the home-user level is really not that great; neither is at the SMB or enterprise level because the equipment costs money, the monitoring and the management for new hardware costs money and it’s not worth it upgrading every couple of years. Wireless Test (5GHz)The Ubiquiti U6-Pro UniFi WiFi 6 Access Point is an indoor WiFi 6 AP with 5.3Gbps over the air speed and a 300+ client capacity. The U6-Pro is a dual-band WiFi 6 (802.11ax) access point that represents the next generation of high-performance wireless technology for home and enterprise users. Delivering blazing fast over the air speeds of up to 5.3 Gbps over its 5GHz and 2.4GHz channels, the U6-Pro will maximise the WiFi experience of any residential or office deployment. Plus, with its ability to support over 300 concurrent clients, the U6-Pro ensures reliable wireless coverage across even the most device-dense environments. The U6-Pro also marries power with ease of use through streamlined setup, configuration, and mobile-friendly management via the UniFi Network app. Key Features The AC-Mesh is an AC1200 Wi-Fi 5 AP that is getting old, but it’s still for sale and a valid option for new outdoor installations. The AC-Mesh comes with removable omnidirectional antennas, which can be replaced with any antenna that has RP-SMA connectors. The AC-Mesh can operated on standard 802.3af (15W) PoE, or with Ubiquiti’s 24V passive PoE. I explained my current home network in Zen and the Art of Home Networking. In that post I walked through my home network and why I chose the APs and locations that I did. I’ve used the U6-Lite, U6-LR, U6-Pro, U6-Mesh, and several other models and vendors. The differences aren’t always what you would expect from the spec sheet.